Jump to content

Hydrostatic weighing

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Citation bot (talk | contribs) at 20:29, 8 July 2022 (Add: s2cid, issue. | Use this bot. Report bugs. | Suggested by Abductive | #UCB_webform 496/3850). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Hydrostatic weighing, also referred to as "underwater weighing", "hydrostatic body composition analysis", and "hydrodensitometry" is a technique for measuring the density of a living person's body. It is a direct application of Archimedes' principle, that an object displaces its own volume of water.

Method

The procedure is based on Archimedes' principle, which states that: The buoyant force which water exerts on an immersed object is equal to the weight of water that the object displaces.

Example 1: If a block of solid stone weighs 3 kilograms on dry land and 2 kilogram when immersed in a tub of water, then it has displaced 1 kilogram of water. Since 1 liter of water weighs 1 kilogram (at 4 °C), it follows that the volume of the block is 1 liter and the density (mass/volume) of the stone is 3 kilograms/liter.

Example 2: Consider a larger block of the same stone material as in Example 1 but with a 1-liter cavity inside of the same amount of stone. The block would still weigh 3 kilograms on dry land (ignoring the weight of air in the cavity) but it would now displace 2 liters of water so its immersed weight would be only 1 kilogram (at 4 °C).

In either of the examples above, the correct density can be calculated by the following equation:

Where: Db = Density of the body, Ma = "Mass in air" (i.e. dry weight), Mw = "Mass in water" (i.e. underwater weight), Dw = Density of water (based on water temperature), RV = Residual volume (the unfilled space enclosed by the body- e.g. volume of air in the lungs + respiratory passages after a maximum exhalation).

The residual volume in the lungs can add error if not measured directly or estimated accurately. Residual volume can be measured by gas dilution procedures or estimated from a person's age and height:[1]

  • Inches: RV-Est(Men) = 0.033 X Ht. (inches) + 0.022 X Age (yrs.) - 1.232
  • Metric: RV-Est(Men) = 1.310 X Ht. (meters) + 0.022 X Age (yrs.) - 1.232
  • Inches: RV-Est(Women) = 0.046 X Ht. (inches) + 0.016 X Age (yrs.) - 2.003
  • Metric: RV-Est(Women) = 1.812 X Ht. (meters) + 0.016 X Age (yrs.) - 2.003

Residual volume may also be estimated as a proportion of vital capacity (0.24 for men and 0.28 for women).[2]

Application

Once body density has been calculated from the data obtained by hydrostatic/underwater weighing, body composition can be estimated. The most commonly used equations for estimating the percent of body fat from density are those of Siri[3] and Brozek et al.:[4]

Siri (1956): Fat % = [4.950 /Density - 4.500]×100

Brozek et al. (1963): Fat % = [4.570 /Density - 4.142]×100

References

  1. ^ Quanjer P.H., Ed. (1983). "Standardized Lung Function Testing". European Community for Coal and Steel, Luxembourg. {{cite journal}}: Cite journal requires |journal= (help)
  2. ^ Wilmore, J. H. (1969). "The use of actual predicted and constant residual volumes in the assessment of body composition by underwater weighing". Med Sci Sports. 1 (2): 87–90. doi:10.1249/00005768-196906000-00006.
  3. ^ Siri, SE (1961), "Body composition from fluid spaces and density: analysis of methods", in Brozek J, Henschel A (eds.), Techniques for measuring body composition, Washington, DC: National Academy of Sciences, National Research Council, pp. 223–34
  4. ^ Brozek J, Grande F, Anderson JT, Keys A (September 1963), "Densitometric Analysis of Body Composition: Revision of some Quantitative Assumptions", Ann. N. Y. Acad. Sci., 110: 113–40, doi:10.1111/j.1749-6632.1963.tb17079.x, PMID 14062375, S2CID 2191337

See also